Dodge Omni/Horizon/Rampage 1978-1989 Repair Guide

Turn Signal Switch

Print

REMOVAL & INSTALLATION



  1. Disconnect the electrical connector at column.
  2.  
  3. Remove the steering wheel as described earlier.
  4.  
  5. Remove the lower column cover.
  6.  



Click image to see an enlarged view

Fig. Fig. 1 Remove the horn button from the steering wheel



Click image to see an enlarged view

Fig. Fig. 2 Using a flat-bladed tool, remove the screws on the horn switch



Click image to see an enlarged view

Fig. Fig. 3 Next remove the horn switch from the wheel



Click image to see an enlarged view

Fig. Fig. 4 Unscrew the wheel nut



Click image to see an enlarged view

Fig. Fig. 5 Mark the location of the wheel and shaft for installation



Click image to see an enlarged view

Fig. Fig. 6 Install a steering wheel puller on the shaft



Click image to see an enlarged view

Fig. Fig. 7 Pull the wheel off of the steering shaft



Click image to see an enlarged view

Fig. Fig. 8 Unscrew the column cover to access the switch

  1. Remove the wash/wipe switch.
  2.  
  3. Remove the wiring clip and the three screws securing the turn signal switch.
  4.  



Click image to see an enlarged view

Fig. Fig. 9 Remove the three screws that hold the turn signal switch in place

  1. Installation is the reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo