The fluid level should be checked with engine off to prevent injury from moving components.
Use MOPAR® Power Steering Fluid (2001) or MOPAR® ATF+4 (2002 and later) is to be used in the power steering system. No other power steering or automatic transmission fluid is to be used in the system. Damage may result to the power steering pump and system if any other fluid is used. Do not overfill.
- Wipe filler cap clean, then check the fluid level. The dipstick should indicate COLD when the fluid is at normal temperature (before engine has been operated).
- Turn steering wheel all the way to the left
- Fill the pump fluid reservoir to the proper level and let the fluid settle for at least two (2) minutes.
- Raise the front wheels off the ground.
Slowly turn the steering wheel lock-to-lock 20 times with the engine
while checking the fluid level.
NOTEVehicles with long return lines or oil coolers turn wheel 40 times.
- Start the engine. With the engine idling maintain the fluid level.
- Lower the front wheels and let the engine idle for two minutes.
- Turn the steering wheel in both direction and verify power assist and quiet operation of the pump.
If the fluid is extremely foamy or milky looking, allow the vehicle to stand a few minutes and repeat the procedure.
WARNINGDo not run a vehicle with foamy fluid for an extended period. This may cause pump damage.