- Secure the master cylinder in a bench vise using soft jaws.
- Remove the master cylinder reservoir cap.
- Manufacture or purchase bleeding tubes and install them on the master cylinder as illustrated.
- Fill the master cylinder reservoir with clean, fresh brake fluid until the level is within 0.25 in. of the reservoir top.
Ensure the bleeding tubes are below the level of the brake fluid, otherwise air may get into the system making your bleeding efforts ineffective.
- Use a blunt tipped rod (a long socket extension works well) to slowly depress the master cylinder piston. Make sure the piston travels full its full stroke.
- As the piston is depressed, bubbles will come out of the bleeding tubes. Continue depressing and releasing the piston until all bubbles cease.
- Refill the master cylinder with fluid.
- Remove the bleeding tubes.
- Install the master cylinder reservoir cap.
- Install the master cylinder on the vehicle.
When any part of the hydraulic system has been disconnected for repair or replacement, air may get into the lines and cause spongy pedal action (because air can be compressed and brake fluid cannot). To correct this condition, it is necessary to bleed the hydraulic system so to be sure all air is purged.
When bleeding the brake system, bleed one brake cylinder at a time, beginning at the cylinder with the longest hydraulic line (farthest from the master cylinder) first. ALWAYS Keep the master cylinder reservoir filled with brake fluid during the bleeding operation. Never use brake fluid that has been drained from the hydraulic system, no matter how clean it is.
The primary and secondary hydraulic brake systems are separate and are bled independently. During the bleeding operation, do not allow the reservoir to run dry. Keep the master cylinder reservoir filled with brake fluid.
- Clean all dirt from around the master cylinder fill cap, remove the cap and fill the master cylinder with brake fluid until the level is within 1 / 4 in. (6mm) of the top edge of the reservoir.
- Clean the bleeder screws at all 4 wheels. The bleeder screws are located on the back of the brake backing plate (drum brakes) and on the top of the brake calipers (disc brakes).
- Attach a length of rubber hose over the bleeder screw and place the other end of the hose in a glass jar, submerged in brake fluid.
- Open the bleeder screw 1 / 2 - 3 / 4 turn. Have an assistant slowly depress the brake pedal.
- Close the bleeder screw and tell your assistant to allow the brake pedal to return slowly. Continue this process to purge all air from the system.
- When bubbles cease to appear at the end of the bleeder hose, close the bleeder screw and remove the hose. Tighten the bleeder screw to the proper torque: