Honda CRV/Odyssey 1995-2000 Repair Information

Throttle Position Sensor



See Figures 1 and 2

Click image to see an enlarged view

Fig. Fig. 1: Exploded view of a typical Honda Throttle Position (TP) sensor

Click image to see an enlarged view

Fig. Fig. 2: Output voltage vs. throttle opening of a TP sensor

The Throttle Position (TP) sensor is a potentiometer that provides a signal to the PCM that is directly proportional to the throttle plate position. The TP sensor is mounted on the side of the throttle body and is connected to the throttle plate shaft. The TP sensor monitors throttle plate movement and position, and transmits an appropriate electrical signal to the PCM. These signals are used by the PCM to adjust the air/fuel mixture, spark timing and if installed, EGR operation according to engine load at idle, part throttle, or full throttle. The TP sensor is not adjustable.

The TP sensor receives a 5 volt reference signal and a ground circuit from the PCM. A return signal circuit is connected to wiper that runs on a resistor internally on the sensor. The further the throttle is opened, the further the wiper moves along the resistor. At full throttle, the wiper essentially creates a loop between the reference signal and the signal return returning the full or nearly full 5 volt signal back to the PCM. At idle the signal return should be approximately 0.9 volts.

The PCM compares the TP sensor with the MAP sensor to determine if the system is functioning properly.


See Figure 3

Click image to see an enlarged view

Fig. Fig. 3: The TP sensor can be monitored with an appro