Envoy, Rainer, Trailblazer 2006-2007

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the fuel sender assembly.
  4.  
  5. Push down the fuel level sensor pigtail electrical connector retainer and remove the connector from the module cover.
  6.  
  7. Remove the fuel level sensor pigtail wires from behind the retainer on the bucket.

    Click image to see an enlarged view

    Fig. Push in the fuel level sensor retainer (1) on the bucket



    Click image to see an enlarged view

    Fig. Slide down the fuel level sensor and remove the sensor from the bucket

  8.  
  9. Push in the fuel level sensor retainer (1) on the bucket.
    NOTE
    Note the orientation of the fuel level sensor float during removal.

  10.  
  11. Slide down the fuel level sensor and remove the sensor from the bucket.
  12.  

To install:

  1. Position the fuel level sensor to the bucket and slide the fuel level sensor up into position.
  2.  
  3. Ensure that the fuel level sensor is fully engaged by the retainer on the bucket.
  4.  
  5. Install the fuel level sensor pigtail wires behind the retainer on the bucket.
  6.  
  7. Connect the fuel level sensor pigtail electrical connector to the module cover and ensure that the retainer if fully engaged.
  8.  
  9. Install the fuel sender assembly.
  10.  
  11. Connect the negative battery cable.
  12.  

 
label.common.footer.alt.autozoneLogo