Envoy, Rainer, Trailblazer 2006-2007

Brake Pads

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    2 / 3 of the brake fluid from the master cylinder
     
    Wheels
     

  4.  
  5. Place a C-clamp around the outer pad and caliper; tighten the C-clamp until the piston is fully compressed in the caliper.

    Top caliper retainer, and rotate caliper away from rotor
     
    Inboard pad and retaining spring from the caliper
     
    Outboard pad from the caliper
     

  6.  

To install:

  1. Clean and lubricate the sleeves and bushing with silicone lubricant
  2.  
  3. Install or connect the following:

    Sleeves and bushings into the caliper
     
    Clip the retaining spring onto the inboard pad and install the pad in the caliper
     
    Outboard pad into the caliper
     
    Caliper in position over the rotor and install the mounting bolts
     
    Wheel and tire assemblies
     

  4.  
  5. Refill the master cylinder and pump pedal to attain full brake pedal before Road-testing the vehicle.
  6.  

 
label.common.footer.alt.autozoneLogo