Equinox 2005-2007, Torrent 2006-07

Removal & Installation

Print

  1. Remove the instrument panel center trim bezel.
  2.  
  3. Disconnect the electrical connectors.
  4.  
  5. Remove the control panel mounting screws and remove the control panel from the trim bezel.
  6.  
  7. Installation is the reverse order of removal.
  8.  
  9. Calibrate the control panel as follows:
    1. Calibrate the mode actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module 3 times each, within 2 seconds of initial push.
    2.  
    3. Calibrate the mode actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module 3 times each, within 2 seconds of initial push.
      NOTE
      The A/C and RECIRC button LED's will flash while this calibration is taking place.


      NOTE
      The calibration will take anywhere between 10-30 seconds depending on battery voltage.


      NOTE
      The LED's will stop flashing when the calibration is complete.

    4.  
    5. Cycle the ignition and verify proper operation.

      Click image to see an enlarged view

      Fig. After removing the center trim bezel, remove the mounting screws to remove the control panel-2006 Equinox shown



      Click image to see an enlarged view

      Fig. Remove the trim bezel (1), then remove the mounting screws (2) to access the control panel (3)-2007 Equinox shown

    6.  

  10.  

 
label.common.footer.alt.autozoneLogo