Escalade, Suburban 1500 & 2500, Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006)

Blend Door Actuator

Print

Removal & Installation



  1. Remove the right rear quarter trim panel.
  2.  
  3. Disconnect the electrical connector from the actuator.
  4.  
  5. Remove the retaining screws from the actuator.
  6.  
  7. Remove the mode actuator from the housing.

    Click image to see an enlarged view

    Fig. Actuator location, typical

  8.  

To install:

  1. Install the mode actuator to the housing.
  2.  
  3. Install the retaining screws to the actuator and tighten to 14 inch lbs. (1.6 Nm).
  4.  
  5. Connect the electrical connector to the actuator.
  6.  
  7. Install the right rear quarter trim panel.
  8.  
  9. Calibrate the HVAC module actuators, if required.
  10.  

 
label.common.footer.alt.autozoneLogo