Escalade, Suburban 1500 & 2500, Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006)

Throttle Body

Print

Removal & Installation



4.8L, 5.3L, 6.0L And 6.2L Engines

NOTE
The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.

  1. Remove the electrical wire harness connectors from the throttle body.
  2.  
  3. Remove the engine coolant air bleed hose and clamp, if applicable.
  4.  
  5. Remove the throttle body nuts.
  6.  
  7. Remove the throttle body.
  8.  
  9. Remove the throttle body gasket.
  10.  
  11. Discard the gasket.
  12.  
  13. Remove the throttle body studs, if required.

    Click image to see an enlarged view

    Fig. Throttle body-4.8L, 5.3L, 6.0L and 6.2L engines

  14.  

To install:

  1. Install the throttle body studs, if required.
    1. Tighten the throttle body studs to 53 inch lbs. (6 Nm).
      NOTE
      DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.

    2.  

  2.  
  3. Install the new throttle body gasket to the intake manifold.
  4.  
  5. Install the throttle body and nuts.
    1. Tighten the throttle body nuts to 89 inch lbs. (10 Nm).
    2.  

  6.  
  7. Install the engine coolant air bleed hose and clamp to the throttle body, if applicable.
  8.  

8.1L Engine

WARNING
Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.


NOTE
An 8 digit part identification number is stamped on the throttle body casting. Refer to this number if servicing, or part replacement is required.

  1. Remove the intake air resonator.
  2.  
  3. Disconnect the throttle actuator motor electrical connector.
    NOTE
    Cover or plug any openings when servicing the throttle body in order to prevent possible contamination.

  4.  
  5. Remove the throttle body nuts.
  6.  
  7. Remove the throttle body.
  8.  
  9. Remove and discard the throttle body gasket.

    Click image to see an enlarged view

    Fig. Throttle body-8.1L engines

  10.  

To install:

  1. Install a NEW throttle body gasket.
  2.  
  3. Install the throttle body.
  4.  
  5. Install the throttle body nuts.
    1. Tighten the nuts to 89 inch lbs. (10 Nm).
    2.  

  6.  
  7. Connect the throttle actuator motor electrical connector.
  8.  
  9. Install the intake air resonator.
  10.  
  11. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  12.  
  13. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  14.  

 
label.common.footer.alt.autozoneLogo