Escalade, Suburban 1500 & 2500, Tahoe, Yukon, Yukon XL 1500 & 2500 (2006-2007), Yukon Denali and Yukon Denali XL (2005-2006)

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Upper radiator fan shroud, if necessary
     
    Drive belt
     
    Pulley.
     
    Nut and clamp retaining the filler neck to the power steering pump, if equipped
     

  4.  
  5. Place a drain pan under the pump. Remove the hoses from the pump.

    Bolts from the rear of the pump
     
    Bolts from the front of the pump
     
    Pump from the vehicle

    Click image to see an enlarged view

    Fig. Power steering pump-4.8L, 5.3L, 6.0L and 6.2L engines shown

     

  6.  

To install:

  1. Install or connect the following:

    Power steering pump
     
    Bolts to the front and the rear of the pump. Tighten the bolts to 37 ft. lbs. (50 Nm)
     
    Hoses to the pump. Tighten the nut to 20 ft. lbs. (28 Nm)
     
    Nut and clamp retaining the filler neck to the power steering pump, if equipped
     
    Pulley. Install the pulley with 0.020 in (0.5 mm) play
     
    Drive belt
     
    Upper radiator shroud.
     

  2.  
  3. Fill and bleed the power steering system.
  4.  

 
label.common.footer.alt.autozoneLogo