Removal & Installation
The following procedure covers removal & installation only, for the hub assembly. The hub should be disassembled ONLY if overhaul is necessary. In that event, an overhaul kit will be required. Follow the instructions in the overhaul kit to rebuild the hub.
- Before servicing the vehicle, refer to the Precautions section.
Remove or disconnect the following:
Capscrews and washer from the hub cap
- Wipe clean all parts and check for wear or damage.
- Coat all parts with the same wheel bearing grease you've used on the bearings.
Install or connect the following:
Locking unit in the hub
Coat the hub cap O-ring with wheel bearing grease and install the hub cap.
Cap screws and washers. Tighten the screws to 45 inch lbs. (5 Nm).