Disconnect and isolate the battery negative cable before beginning any airbag system component diagnosis, testing, removal, or installation procedures. Allow system capacitor to discharge for two minutes before beginning any component service. This will disable the airbag system. Failure to disable the airbag system may result in accidental airbag deployment, personal injury, or death.
Do not place an intact undeployed airbag face down on a solid surface. The airbag will propel into the air if accidentally deployed and may result in personal injury or death.
When carrying or handling an undeployed airbag, the trim side (face) of the airbag should be pointing towards the body to minimize possibility of injury if accidental deployment occurs. Failure to do this may result in personal injury or death.
Replace airbag system components with original equipment replacement parts. Substitute parts may appear interchangeable, but internal differences may result in inferior occupant protection. Failure to do so may result in occupant personal injury or death.
Wear safety glasses, rubber gloves, and long sleeved clothing when cleaning powder residue from vehicle after an airbag deployment. Powder residue emitted from a deployed airbag can cause skin irritation. Flush affected area with cool water if irritation is experienced. If nasal or throat irritation is experienced, exit the vehicle for fresh air until the irritation ceases. If irritation continues, see a physician.
The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
Do not use a replacement airbag that is not in the original packaging. This may result in improper deployment, personal injury, or death.
To reduce the risk of personal injury, do not use any memory saver devices.
The factory installed fasteners, screws and bolts used to fasten airbag components have a special coating and are specifically designed for the airbag system. Do not use substitute fasteners. Use only original equipment fasteners listed in the parts catalog when fastener replacement is required.
During, and following, any child restraint anchor service, due to impact event or vehicle repair, carefully inspect all mounting hardware, tether straps, and anchors for proper installation, operation, or damage. If a child restraint anchor is found damaged in any way, the anchor must be replaced. Failure to do this may result in personal injury or death.
Deployed and non-deployed airbags may or may not have live pyrotechnic material within the airbag inflator.
Do not dispose of driver/passenger/curtain airbags or seat belt tensioners unless you are sure of complete deployment.
Never probe the connectors on the air bag module or safety canopy module. Doing so can result in air bag deployment, which can result in personal injury.
Dispose of deployed airbags and tensioners consistent with state, provincial, local, and federal regulations.
After any airbag component testing or service, do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.