Removal & Installation
- Before servicing the vehicle, refer to the -Precautions- section and the -Brake Service Precautions- section.
- With the vehicle in NEUTRAL, position it on a hoist.
- Remove the rear wheels.
- Remove the brake hose flow bolt and position the brake hose aside. Discard the 2 copper washers. Cap the fluid ports.
Remove the 2 brake caliper bolts and the brake caliper.
CAUTIONDo not pry in the brake caliper sight hole to retract the pistons as this can damage the pistons and boots.
If leaks or damaged boots are found, install a new brake caliper.
- Position the brake caliper and install the 2 bolts. Torque the bolts to 24 ft. lbs. (32 Nm).
- Using 2 new copper washers, position the brake hose and install the brake hose flow bolt. Tighten the bolt to 26 ft. lbs. (35 Nm).
- Bleed the brake caliper. See -Brake Caliper Bleeding- above.
- Install the wheels and lower the vehicle.
- Test the brake system for normal operation.