REMOVAL & INSTALLATION
See Figure 1
- Disconnect the battery cables (negative cable first).
- Remove the battery from the engine compartment.
- Disengage the two actuator assembly electrical connections from the bracket.
- Disengage the actuator assembly electrical connector.
Make a note of the brake line routing, as this will help during installation.
Clean, high quality brake fluid is essential to the safe and proper operation of the brake system. You should always buy the highest quality brake fluid that is available. If the brake fluid becomes contaminated, drain and flush the system, then refill the master cylinder with new fluid. Never reuse any brake fluid. Any brake fluid that is removed from the system should be discarded. Also, do not allow any brake fluid to come in contact with a painted surface; it will damage the paint.
- Use a line wrench to loosen the brake line flare nuts and disconnect the lines from the actuator.
- Loosen the actuator retaining nuts and remove the actuator.
- Install the actuator and tighten its retaining nuts to 14-16 ft. lbs. (19-22 Nm).
- Connect the brake lines to the actuator and use a flare nut wrench to tighten the fittings to 10-15 ft. lbs. (13-21 Nm).
- Engage the actuator assembly and bracket electrical connections.
- Install the battery and connect the battery cables (positive cable first).
- Bleed the brake system.