REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4 and 5
Fig. Fig. 1: Location of the shift console retaining screws and fasteners
Remove the parking brake console.
Remove the gear shift knob or handle.
Loosen the two console panel screws and two panel fasteners.
Remove the console and disengage any electrical connections.
Fig. Fig. 2: Loosen the two gear shift knob retaining screws (front and side) and remove the knob
Fig. Fig. 3: Loosen the two console panel screws (access to the screws is possible through a slot in the seat rail)
Fig. Fig. 4: Disengage the two clip fasteners (one on each side) and slide the console back
Fig. Fig. 5: Disengage all the electrical connections at the rear and remove the console
Engage any electrical connections and install the shift console.
Tighten the panel screws and engage the fasteners.
Install the gear shift knob or handle.
Install the parking brake console.