Ford Aspire 1994-1998 Repair Guide

EEC-IV Systems



One part of the Powertrain Control Module (PCM) is devoted to monitoring both input and output functions within the system. This ability forms the core of the self-diagnostic system. If a problem is detected within a circuit, the controller will recognize the fault, assign it an identification code, and store the code in a memory section. Depending on the year and model, the fault code(s) may be represented by two or three-digit numbers. The stored code(s) may be retrieved during diagnosis.

While the EEC-IV system is capable of recognizing many internal faults, certain faults will not be recognized. Because the computer system sees only electrical signals, it cannot sense or react to mechanical or vacuum faults affecting engine operation. Some of these faults may affect another component which will set a code. For example, the PCM monitors the output signal to the fuel injectors, but cannot detect a partially clogged injector. As long as the output driver responds correctly, the computer will read the system as functioning correctly. However, the improper flow of fuel may result in a lean mixture. This would, in turn, be detected by the oxygen sensor and be noticed as a constantly lean signal by the PCM. Once the signal falls outside the pre-programmed limits, the engine control assembly would notice the fault and set an identification code.

Failure Mode Effects Management (FMEM)

The PCM contains back-up programs which allow the engine to operate if a sensor signal is lost. If a sensor input is seen to be out of range-either high or low-the FMEM program is used. The processor substitutes a fixed value for the missing sensor signal. The engine will continue to operate, although performance and driveability may be noticeably reduced. This function of the controller is sometimes referred to as the limp-in or fail-safe mode. If the missing sensor signal is restored, the FMEM system immediately returns the system to normal operation. The dashboard warning lamp will be lit when FMEM is in effect.

Hardware Limited Operation Strategy (HLOS)

This mode is only used if the fault is too extreme for the FMEM circuit to handle. In this mode, the processor has ceased all computation and control; the entire system is run on fixed values. The vehicle may be operated, but performance and driveability will be greatly reduced. The fixed or default settings provide minimal calibration, allowing the vehicle to be carefully driven in for service. The dashboard warning lamp will be lit when HLOS is engaged. Codes cannot be read while the system is operating in this mode.