REMOVAL & INSTALLATION
See Figures 1, 2 and 3
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes and wash your hands thoroughly after handling brake fluid. If you do get brake fluid in your eyes, flush your eyes with clean, running water for 15 minutes. If eye irritation persists, or if you have taken brake fluid internally, IMMEDIATELY seek medical assistance.
- Disconnect the negative battery cable.
- Remove the master cylinder assembly.
- Disconnect the vacuum supply hose from the booster.
- Remove the four brake booster retaining nuts.
- Gently pull the booster forward, and while holding the booster assembly away from the firewall, have an assistant remove the push rod retainer from the push rod.
- Remove the booster assembly.
- Position the brake booster onto the vehicle and have an assistant guide the push rod onto the retainer.
- Place the booster onto the mounting studs and tighten the retaining nuts to 29 ft. lbs. (40 Nm).
- Connect the vacuum supply hose to the booster.
- Install the master cylinder assembly.
- Connect the negative battery cable.
- Bleed the brake system.