Removal & Installation
6.0L Diesel Engine
- Remove the crankshaft vibration damper as outlined in this section.
Punch 2 holes in the seal.
Using the special tool 303-D060, remove the crankshaft seal.
NOTEProduction engines will not have a wear sleeve.
If equipped, remove the crankshaft damper wear sleeve.
- Thoroughly clean the crankshaft front seal mounting surface.
Apply Threadlock 262 to the outer circumference of the leading edge of the crankshaft.
NOTENew seal and wear sleeve must not be separated.
Using the special tool 303-761, install the oil seal and wear sleeve assembly.
- Install the crankshaft damper.