REMOVAL & INSTALLATION
Fig. Fig. 1 Use a slide hammer and seal installer for axle shaft oil seal replacement
Remove the axle shaft from the rear axle, as described earlier in this section.
Using a two-fingered seal puller or a slide hammer (such as Tools T50T-100-A, T58L-101-A, Tool-1175 Ac or OTC-960), remove the seal from the axle housing.
Clean the recess in the rear axle housing, from which the seal was removed.
Position a new seal on the housing and drive it into the housing with a seal installation tool (such as Tool No. T79P-1177-A).
Install the axle shaft.