REMOVAL & INSTALLATION
The wiper linkage is mounted below the cowl top grille. The pivot shafts and linkage assemblies are connected together with non-removeable plastic ball joints. The left- and right-hand pivot shafts and linkage are serviced as one unit.
- Disconnect the battery.
- Remove the cowl top grille attaching screws and the grille.
- Remove the clip and disconnect the linkage drive arm from the motor crank pin.
- Remove the two bolts retaining the right pivot shaft to the cowl, and remove the large nut, washer and spacer from the left pivot shaft.
- To install reverse the removal procedure. Before installing the blade assemblies, make sure the motor is in PARK and the blades are set to the proper dimension. See the Arm and Blade Adjustment procedure.