Ford Freestar, Monterey 2004-2006

Oil Pressure Sensor

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the alternator, as outlined in this section.
  4.  
  5. Remove the accessory drive belt idler pulley.
  6.  
  7. Remove the alternator brace bolt.
  8.  
  9. Remove the 2 A/C compressor mounting bracket brace bolts.
    NOTE
    Clearance between the engine and vehicle frame is limited.

  10.  
  11. Remove the A/C compressor mounting bracket brace, 2 long bolts and generator mounting bracket from the engine as an assembly.
  12.  
  13. Disconnect the oil pressure sender electrical connector.
  14.  
  15. Remove the oil pressure sender.
  16.  

To install:

  1. Install the oil pressure sender. Tighten to 20 ft. lbs. (27 Nm).
  2.  
  3. Attach the oil pressure sender electrical connector.
  4.  
  5. Install the A/C compressor mounting bracket brace, 2 long bolts and generator mounting bracket to the engine as an assembly. Tighten to 35 ft. lbs. (47 Nm).
  6.  
  7. Install the A/C compressor mounting bracket brace bolts and tighten to 18 ft. lbs. (25 Nm).
  8.  
  9. Install the alternator brace bolt and tighten to 35 ft. lbs. (47 Nm).
  10.  
  11. Install the accessory drive belt idler pulley.
  12.  
  13. Install the alternator.
  14.  
  15. Connect the negative battery cable.
  16.  

 
label.common.footer.alt.autozoneLogo