REMOVAL & INSTALLATION
- Remove any hubcaps or protective covers over the tire retaining hardware.
- Loosen each lugnut 1 / 2 turn.
- Raise and safely support the vehicle on jackstands.
- Remove the lugnuts from the wheel, then remove the wheel and tire assembly.
For detailed wheel removal and installation procedures, see Routine Maintenance .
Replace any wheel that is bent, dented or heavily rusted, has air leaks (aluminum wheels can, in some instances, be repaired), elongated bolt holes, or has excessive lateral or radial runout. Wheels with excessive lateral or radial runout can cause a high-speed vehicle vibration.
The replacement wheels must be of the same load capacity, diameter, width, offset and mounting configuration as the original equipment wheels. Improper wheels may affect wheel and bearing life, ground and tire clearance, or speedometer and odometer calibrations.