REMOVAL & INSTALLATION
See Figures 1 through 7
Fig. Fig. 1: Blower motor resistor assembly
Fig. Fig. 2: Push in the sides of the glove compartment door to allow it to drop down
Fig. Fig. 3: This cover may need to be removed to reach the blower motor
Fig. Fig. 4: The blower motor wiring may be held by a push in tab
Fig. Fig. 5: The motor cooling hose pushes onto its fitting
Fig. Fig. 6: Note that the mounting flange has locator tabs in it allowing it to fit in only one orientation
Fig. Fig. 7: Check the fan blades for damage and for debris in the housing
Disconnect the negative battery cable.
Disconnect the blower motor resistor wiring harness.
Remove the two screws that attach the resistor board to the evaporator case and remove the resistor assembly.
Installation is the reverse of the removal procedure.