REMOVAL & INSTALLATION
See Figures 1 through 10
Fig. Fig. 1: Wiper linkage clip removal
Fig. Fig. 2: Wiper linkage assembly
Fig. Fig. 3: Remove the screws to allow removal of the cowl grill
Fig. Fig. 4: Disconnect the washer hose. This is a good time to force water backwards through the washer nozzles to clean them
Fig. Fig. 5: This clips holds the linkage to the wiper motor
Fig. Fig. 6: Lubricate the bushings to help extend the life of the linkage
Fig. Fig. 7: The wiper motor has two electrical connections. Remember this one when installing the motor
Fig. Fig. 8: Pull back the latch before trying to disconnect the harness from the motor
Fig. Fig. 9: The wiper motor is suspended in these rubber mounts. Do not overtighten the bolts or the mounts will be crushed
Fig. Fig. 10: Check the gasket around the motor before installing
Disconnect the negative battery cable.
Remove both wiper arm and blade assemblies.
Remove the cowl grille attaching screws and lift the cowl grille slightly.
Disconnect the washer nozzle hose and remove the cowl grille assembly.
Remove the wiper linkage clip from the motor output arm.
Unplug the wiper motor's wiring connector.
Remove the wiper motor's three attaching screws and remove the motor.
Install the motor and attach the three attaching screws. Tighten to 60-85 inch lbs.
Plug in wiper motor's wiring connector.
Install wiper linkage clip to the motors output arm.
Connect the washer nozzle hose and install the cowl assembly and attaching screws.
Install both wiper arm assemblies.
Connect negative battery cable.