REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5, 6, 7 and 8
Remove the bezel retaining screws.
Disconnect the negative battery cable.
Remove the screws securing the radio mounting plate to the instrument panel and pull out the radio.
Disconnect the antenna cable, speaker wires and power wire.
Installation is the reverse of removal.
Fig. Fig. 1: Remove the radio trim cover-1990 F-150 shown
Fig. Fig. 2: Remove the radio retaining screws
Fig. Fig. 3: Carefully pull the radio out of the cavity
Fig. Fig. 4: Unplug the antenna connector
Fig. Fig. 5: Disengage the harness connector from the radio
Fig. Fig. 6: 1988-96 radio installation
Fig. Fig. 7: Radio suppression equipment-pickups. These, along with the spark plug wires and radio itself, are the areas to check when radio reception becomes poor
Fig. Fig. 8: 1987 radio installation