The Mass Air Flow (MAF) sensor directly measures the amount of the air flowing into the engine. The sensor is mounted between the air cleaner assembly and the air cleaner outlet tube.
The sensor utilizes a hot wire sensing element to measure the amount of air entering the engine. The sensor does this by sending a signal, generated by the sensor when the incoming air cools the hot wire down, to the PCM. The signal is used by the PCM to calculate the injector pulse width, which controls the air/fuel ratio in the engine. The sensor and plastic housing are integral and must be replaced if found to be defective.
The sensing element (hot wire) is a1 thin platinum wire wound on a ceramic bobbin and coated with glass. This hot wire is maintained at 392°F (200°C) above the ambient temperature as measured by a constant "cold wire''.
Removal & Installation
- Disconnect the negative battery cable.
- Disconnect the Mass Air Flow (MAF) sensor electrical connector
- Remove the 2 bolts, the MAF sensor and discard the gasket.
To install, reverse the removal procedure and tighten mounting bolts to 8 ft. lbs. (11 Nm).
NOTEThe MAF sensor module and body are calibrated and installed as a unit.
WARNINGDo not tamper with the MAF sensing elements located in the airflow bypass. Tampering may result in failure.
With the engine running at idle, use a DVOM to verify there is at least 10.5 volts between terminals A and B of the MAF sensor connector. This indicates the power input to the sensor is correct. Then, measure the voltage between MAF sensor connector terminals C and D. If the reading is approximately 0.34-1.96 volts, the sensor is functioning properly.