REMOVAL & INSTALLATION
See Figures 1, 2, 3, 4, 5, 6 and 7
Fig. Fig. 1: Exploded view of the ETR radio and the wire harness connections
Fig. Fig. 2: Some models may require a special tool to release the radio securing clips to allow removal
Fig. Fig. 3: To remove the ETR radio, first remove the ash tray, then the lower fascia from the dash panel
Fig. Fig. 4: Remove the dash trim panel retaining screws and the panel
Fig. Fig. 5: If equipped, remove the radio support bracket attaching screws, otherwise release the retaining clips using a special tool
Fig. Fig. 6: Pull the radio out from the dashboard and unplug all the wire harness connections ...
Fig. Fig. 7: ... as well as the antenna plug from the back of the radio and remove it from the vehicle
Disconnect the negative battery cable.
Remove the finish panel from around the radio assembly.
Insert the radio removal tool T87P-19061-A or equivalent, into the radio face.
Pull the radio out of the instrument panel.
Disconnect the wiring connectors and antenna from the radio and remove it.
Connect the wiring and slide the radio into the instrument panel.
Install the finish panel and connect the battery cable.
Check the operation of the radio.