Ford Ranger/Explorer/Mountaineer 1991-1999

Rear Output Shaft Seal



See Figures 1 and 2

Click image to see an enlarged view

Fig. Fig. 1: Remove the rear output shaft seal-slide hammer and seal removal tool shown

  1. Raise and safely support the vehicle.
  3. Matchmark the rear driveshaft to the transfer case yoke then disconnect the shaft from the yoke. Wire the driveshaft up and out of the way.
  5. Using a 30mm (1.18 in.) thin-wall socket, remove the rear output shaft yoke retaining nut.

Some fluid may dribble out as the yoke is removed, and then again when the seal is removed. While an old rag should suffice for catching the fluid, a small catch can may be better, especially if the vehicle is not parked level.

  1. Remove the output shaft yoke washer, rubber seal and the yoke from the output shaft.
  3. Remove the rear output shaft seal by prying and pulling on the curved outer lip of the seal or by using Impact Slide Hammer Tool T50T-100-A and Seal Remover T74P-77248-A or equivalent. Take care to not damage the bearing, bearing cage or case.

To install:
  1. Ensure that the output housing bore is free of any dirt, burrs or nicks. Apply premium long-life grease to the seal lip.
  3. Position the new seal to the output housing and using an appropriate driver, such as the Output Shaft Seal Replacer T83T-7065-B and Driver Handle T80T-4000-W, press the seal into the housing until fully seated.
  5. Install the rear out put shaft yoke, rubber seal and washer.
  7. Install the output shaft yoke retaining nut and tighten to 250-280 ft. lbs. (339-381 Nm).
  9. Connect the rear driveshaft to the transfer case.
  11. Lower the vehicle.
  13. Drive the vehicle and check for leaks.

Click image to see an enlarged view

Fig. Fig. 2: Drive the new seal into the case housing using the appropriate seal installation tool