- Before servicing the vehicle, refer to the Precautions Section.
Remove or disconnect the following:
Negative battery cable
- Using Special Tool Remover 204-069, press the outer CV-joint until is it loose in the hub.
- Raise the wheel knuckle and remove the CV-joint.
- Using Special Tool 205-475, separate the inner CV-joint from the differential side gear.
Remove the halfshaft.
Install or connect the following:
Halfshaft inner joint to the differential side gear using a new axle circlip
Check the wheel alignment and adjust as necessary.
NOTEIf the hub is removed for any reason, a new bearing assembly must be installed. Never attempt to re-use a bearing.