Loosen the two switch adjusting screws.
Place the transmission lever in
Rotate the switch and insert a No. 43 drill bit, shank end into the gauge pin holes of the switch.
The drill bit must be inserted about
in. (12.7mm) into the three holes.
Tighten the attaching bolts and remove the drill bit.
Fig. Fig. 1 Install the throttle valve linkage control cable locking tab as shown-AOD transmission
Fig. Fig. 2 Remove or install the shift linkage grommet as shown
Fig. Fig. 3 Adjust the TV cable as shown
Fig. Fig. 4 Adjust the shift linkage where shown in this exploded view
Fig. Fig. 5 C6 neutral start switch
Fig. Fig. 6 Removing the AOD neutral start switch