Forenza 2007

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the center molding.

    Click image to see an enlarged view

    Fig. Center molding and cables

  4.  
  5. Disconnect the mode control cable from the mode door.
  6.  
  7. Disconnect the temperature control cable eyelet from the post on the controller.
  8.  
  9. Pry off the clip of the temperature control cable.

    Click image to see an enlarged view

    Fig. Control cables

  10.  
  11. Pry off the Clip of the temperature cable.

    Click image to see an enlarged view

    Fig. Temperature door lever and cable

  12.  

To install:

  1. Install the temperature control cable eyelet to the post on the temperature door lever.
  2.  
  3. Install the clip of the temperature cable.
  4.  
  5. Install the temperature control cable eyelet to the post on the controller.
  6.  
  7. Install the clip of the temperature control cable.
  8.  
  9. Install the mode control cable to the mode door
  10.  
  11. Insert the center molding into position on the instrument panel.
  12.  
  13. Move the temperature control to verify the smooth operation and function of the door and the cable.
  14.  
  15. Connect the negative battery cable.
  16.  
  17. Operate the heating and cooling systems to verify proper function.
    NOTE
    Because the cable and the cable housings have fixed lengths, it is impossible to make a temperature cable adjustment. In addition, the heater/air distributor case linkage cannot be adjusted.

  18.  

 
label.common.footer.alt.autozoneLogo