Forenza 2007

Crankshaft Gear

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the air filter housing assembly bolts and the air intake tube.
  4.  
  5. Remove the air filter housing assembly from the vehicle.
  6.  
  7. Use a wrench to turn the tensioner bolt clockwise, compressing the tensioner, and releasing the tension on the serpentine accessory drive belt.
  8.  
  9. Remove the serpentine accessory drive belts.
  10.  
  11. Remove the crankshaft pulley.
  12.  

To install:

  1. Install the crankshaft pulley.
  2.  
  3. Tighten the crankshaft gear bolt to 107 ft. lbs. (145 Nm) plus 30° plus 15° using the angular torque gauge KM-470-B.
  4.  
  5. Use a wrench to turn the tensioner bolt clockwise, compressing the tensioner, and releasing the tension on the serpentine accessory drive belt.
  6.  
  7. With the wrench in place on the tensioner bolt, loop the serpentine accessory drive belt loosely over the pulleys.
  8.  
  9. Slip the belt over the tensioner.
  10.  
  11. Remove the wrench from the tensioner bolt and the belt will tighten itself.
  12.  
  13. Install the air filter housing assembly into the vehicle.
  14.  
  15. Install the air intake tube and the air filter housing assembly bolts.
  16.  
  17. Tighten the air filter housing assembly bolts to 53inch lbs.(6 Nm).
  18.  
  19. Connect the negative battery cable.
  20.  

 
label.common.footer.alt.autozoneLogo