Forenza 2007

Removal & Installation

Print

  1. Disconnect the insulator connector.

    Click image to see an enlarged view

    Fig. Fuel level sending unit

  2.  
  3. Push the terminal wedge (1) in the insulator connector.

    Click image to see an enlarged view

    Fig. Fuel sending unit connector assembly

  4.  
  5. Push the wedge (1) outside and then pull the wires to disconnect from insulator.

    Click image to see an enlarged view

    Fig. Fuel sending unit wire removal

  6.  
  7. Remove the fuel-level sensor (1) from the sender-housing (2).
  8.  
  9. Remove the sender-housing (2).

    Click image to see an enlarged view

    Fig. Fuel sending unit level sensor removal

  10.  
  11. Remove fuel sender assembly (3).

    Click image to see an enlarged view

    Fig. Fuel sending unit removal

  12.  

To install:

  1. Wind the wires (1) the sender assembly (2).

    Click image to see an enlarged view

    Fig. Fuel sending unit removal

  2.  
  3. Install the sender assembly onto the fuel pump assembly (1).
  4.  
  5. Install the fuel-level sensor onto the sender-housing.
  6.  
  7. Connect the wire into the insulator connector

    Click image to see an enlarged view

    Fig. Fuel Sending unit removal

  8.  
  9. Connect the insulator connector.
  10.  

 
label.common.footer.alt.autozoneLogo