Forenza 2007

Cables

Print

Removal & Installation



  1. Remove the parking brake / gearshift console hood.
  2.  
  3. Release the parking brake lever and the hex nut on the end of pull rod.

    Click image to see an enlarged view

    Fig. Parking brake lever and hex nut

  4.  
  5. Remove the parking brake cable ends from the equalizer.

    Click image to see an enlarged view

    Fig. Parking brake cable ends and equalizer

  6.  
  7. Raise and suitably support the vehicle.
  8.  
  9. Remove the rear wheels.
  10.  
  11. Remove the detent screw of the rear disc brake and remove the brake disc.
  12.  
  13. Remove the rear hub assembly.
  14.  
  15. Remove the retaining pin.
  16.  
  17. Remove the parking brake cable from the trailing shoe.
  18.  
  19. Remove the bolts securing the parking brake cable to the underbody clip on both the driver and passenger sides of the vehicle.

    Click image to see an enlarged view

    Fig. Cable mounting clips

  20.  
  21. Remove the parking brake cable from the clip near the fuel tank strap.
  22.  
  23. Remove the parking brake cables from the vehicle.
  24.  

To install:

  1. Install the new parking brake cable (if necessary) through the rear disc brake backing plate and attach to the brake trailing shoe lever.
  2.  
  3. Ensure the parking brake cable is routed correctly.
  4.  
  5. Install the rear brake disc by fastening the detent screw.
  6.  
  7. Tighten the rear brake disc detent screw to 35 inch lbs. (4 Nm)
  8.  
  9. Install the parking brake cable to the trailing shoe.
  10.  
  11. Install the retaining pin.
  12.  
  13. Install the rear hub assembly.
  14.  
  15. Install the bolts securing the parking brake cable to a bracket on both the driver and passenger sides of the vehicle.
  16.  
  17. Tighten the parking brake cable-to-underbody side bracket bolts to 53 inch lbs. (6 Nm)
  18.  
  19. Install the parking brake cable to the clip near the fuel tank strap.
  20.  
  21. Attach the parking brake cable ends to the equalizer.
  22.  
  23. Adjust the hex nut on the end of pull rod.
  24.  
  25. Install the parking brake / gearshift console hood.
  26.  

 
label.common.footer.alt.autozoneLogo