Forenza 2007

Crossmember

Print

Removal & Installation



  1. Raise and suitably support the vehicle.
  2.  
  3. Remove the front parallel link bolt from the crossmember.
  4.  
  5. Remove the rear parallel link bolt from the crossmember.
  6.  
  7. Remove the rear wheel speed sensor wiring from the crossmember.

    Click image to see an enlarged view

    Fig. Speed sensor connector

  8.  
  9. Remove the crossmember-to-body bolts.
  10.  
  11. Remove the crossmember.

    Click image to see an enlarged view

    Fig. Crossmember bolt removal

  12.  

To install:

  1. Install the crossmember.
  2.  
  3. Install the crossmember-to-body bolts.
  4.  
  5. Tighten the crossmember-to-body bolts to 83 ft. lbs. (112 Nm)
  6.  
  7. Route and install the rear wheel speed sensor wiring.
  8.  
  9. Install the rear parallel link bolt onto the crossmember.
  10.  
  11. Install the front parallel link bolt onto the crossmember.
  12.  
  13. Lower the vehicle.
  14.  

 
label.common.footer.alt.autozoneLogo