Honda CRV/Odyssey 1995-2000 Repair Information

Compression Fittings



The compression fitting has a flared metal tube or a compression fitting that is surrounded by a threaded flare nut. Because the tube is flared or has a compression fitting installed, the threaded flare nut cannot be removed from the line and is considered part of the assembly.

Compression fittings are most often used when a pressure line attaches to an assembly, much like the inlet fuel line for the firewall mounted fuel filter found on CRV and 4-cylinder Odyssey models.

The compression fitting does not have a gasket or seal, rather it uses the threaded flare nut to seal the flared end of the line or a compression fitting on the line to the assembly. The flared end of the fuel line or the compression fitting is sealed between the component and the flare nut.

A compression fitting is most often found where the fluid in the line is under considerable pressure.

The flare nut is one of two types:

The externally threaded flare nut: An example of this type of fitting is most easily seen on the CRV and Odyssey models where the flare nut is threaded into the brake master cylinder.
An internally threaded flare nut: This type of fitting uses a compression fitting on the line and the nut threads onto a threaded fitting.

  1. To disconnect a fuel line using a compression fitting, hold the component that the flare nut is threaded onto securely, and using a flare nut type wrench, loosen the flare nut.
  3. Installation is the reverse of the removal procedure.

See Figures 1, 2, 3 and 4

Click image to see an enlarged view

Fig. Fig. 1: An example of an internally threaded flare nut on this fuel line. Note the use of a flare nut wrench; loosen the nut while the component is held with another wrench

Click image to see an enlarged view

Fig. Fig. 2: The open-end wrench on the left compared to a flare nut wrench on the right. The slot allows the flare nut wrench to clear the line, yet will grip the flare nut on all 6 sides

Click image to see an enlarged view

Fig. Fig. 3: The fuel inlet line on a Honda firewall mounted fuel filter is a compression fitting. The flare nut has external threads and is threaded into the bottom of the fuel filter

Click image to see an enlarged view

Fig. Fig. 4: An exploded view of a Honda firewall-mounted fuel filter and mounting bracket. The filter outlet (top) uses a banjo bolt fitting, the inlet (bottom) is a compression fitting