G6 2005-2007

Removal & Installation

Print

  1. Remove the instrument panel (I/P) center trim panel.
  2.  
  3. Remove the HVAC control module screws.
  4.  
  5. Remove the HVAC control module.
  6.  
  7. Remove the HVAC control module wire harness connectors.
  8.  

To install:

  1. Install the HVAC control module wire harness connectors.
  2.  
  3. Install the HVAC control module.
  4.  
  5. Tighten the HVAC control module screws to 22 inch. lbs.(2.5 Nm).
  6.  
  7. Install the I/P center trim panel.
    NOTE
    Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.

  8.  
  9. Start the engine and let run for one minute.
  10.  

 
label.common.footer.alt.autozoneLogo