G6 2005-2007

Ignition Switch

Print

Removal & Installation



  1. Remove the instrument panel (I/P) cluster.
  2.  
  3. Remove the knee bolster.
  4.  
  5. Remove the I/P center trim panel.
  6.  
  7. Remove the ignition switch wire harness connector.
  8.  
  9. Remove the theft deterrent control module wire harness connector.
  10.  
  11. Remove the ignition switch lock cylinder.
  12.  
  13. Disconnect the park lock cable at the ignition switch.
  14.  
  15. Remove the ignition switch at the I/P screws.
  16.  
  17. Remove the ignition switch assembly.
  18.  
  19. Remove the ignition switch bracket screws.
  20.  
  21. Remove the theft deterrent control module.
  22.  
  23. Remove the ignition switch bracket.
  24.  

To install:

  1. Install the ignition switch bracket.
  2.  
  3. Install the theft deterrent control module.
  4.  
  5. Install the ignition switch bracket screws and tighten to 44 inch lbs. (5 Nm).
  6.  
  7. Install the ignition switch.
  8.  
  9. Tighten the ignition switch screws.
  10.  
  11. Connect the park lock cable at the ignition switch.
  12.  
  13. Install the theft deterrent control module wire harness connector.
  14.  
  15. Install the ignition switch wire harness connector.
  16.  
  17. Install the ignition switch lock cylinder.
  18.  
  19. Install the I/P center trim panel.
  20.  
  21. Install the knee bolster.
  22.  
  23. Install the I/P cluster.
  24.  

 
label.common.footer.alt.autozoneLogo