GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide

Heater Core

Print

The heater core is removable from under the right side of the instrument panel.


CAUTION
Please refer to General Information & Maintenance of this guide before discharging/recovering the A/C system or disconnecting air conditioning lines. Damage to the air conditioning system or personal injury could result. Consult your local laws concerning refrigerant discharge and recycling. In many areas it may be illegal for anyone but a certified technician to service the A/C system. Always use an approved recovery station when discharging the air conditioning.

REMOVAL & INSTALLATION



See Figures 1, 2, 3, 4, 5, 6, 7, 8 and 9

  1. Disconnect the negative battery cable.
  2.  
  3. Position a drain pan under the radiator, open the drain cock and drain the cooling system to a level below the heater core.
  4.  

Plug the heater core tubes to avoid spilling coolant in the passenger compartment during removal.

  1. Disconnect the heater-to-engine coolant hoses from the core tubes on the firewall, in the engine compartment.
  2.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of a common heater core and case assembly



Click image to see an enlarged view

Fig. Fig. 2: If necessary, loosen and remove the under dash cabin light retaining bolt



Click image to see an enlarged view

Fig. Fig. 3: With the bolt removed, the light and housing may be repositioned out of the way

On some early model vehicles, the cabin light mounted under the dash may interfere with cover removal. If necessary, loosen the retaining bolt and reposition the light housing with the wiring attached.

  1. From the passenger compartment (under the dash) remove the heater core rear case cover-to-cowl screws, then remove the cover from the vehicle.
  2.  

On a few of the early model vehicles covered by this guide, some of the heater core cover screws may be partially/fully covered by the dashboard. Be sure that all are removed before attempting to remove the cover. If necessary, unbolt and reposition all/part of the dashboard for better access.

  1. Remove the straps or brackets from each end of the heater core.
  2.  
  3. Carefully remove the heater core from the cowl and case.
  4.  

To install:
  1. Insert the heater core into the case, taking care not to damage the tubes as they are inserted through the cowl.
  2.  
  3. Install the straps or brackets to the ends of the heater core and secure using the retaining screws.
  4.  
  5. Install the heater core rear case cover and secure using the retaining screws.
  6.  
  7. If moved for access, reposition and secure the dash mounted cabin light and housing.
  8.  
  9. Connect the heater-to-engine coolant hoses to the core tubes.
  10.  
  11. Connect the negative battery cable, then properly refill the engine cooling system.
  12.  
  13. Run the engine at normal operating temperatures and check for leaks.
  14.  



Click image to see an enlarged view

Fig. Fig. 4: Loosen and remove the rear case cover screws



Click image to see an enlarged view

Fig. Fig. 5: Remove the rear case cover for access to the heater core



Click image to see an enlarged view

Fig. Fig. 6: Loosen and remove the core strap/bracket retainers



Click image to see an enlarged view

Fig. Fig. 7: Remove or reposition the straps/brackets so the core can be removed



Click image to see an enlarged view

Fig. Fig. 8: Most cores are retained by straps/brackets on both ends; don't forget to loosen all retainers



Click image to see an enlarged view

Fig. Fig. 9: Carefully withdraw the heater core from the case

 
label.common.footer.alt.autozoneLogo