GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide

Console

Print

REMOVAL & INSTALLATION



Front Console
  1. If equipped, remove the transfer case shift lever knob.
  2.  
  3. For vehicles equipped with a manual transmission, remove the shift control lever.
  4.  
  5. Pull up on the console to release the retaining clips, then disengage the electrical connector (if equipped) and remove the console from the vehicle.
  6.  
  7. Installation is the reverse of removal.
  8.  

Floor Mounted Console
EXCEPT TYPHOON

See Figure 1

  1. Remove the small bin, then unfasten the screws located beneath it.
  2.  
  3. Remove the large bin, then remove the eyeglass holder.
  4.  
  5. Disengage the electrical connector, then remove the power window and keyless entry module.
  6.  
  7. Unfasten the console-to-mounting bracket screws, then remove the console from the vehicle.
  8.  
  9. Installation is the reverse of removal.
  10.  



Click image to see an enlarged view

Fig. Fig. 1: Floor console components

TYPHOON

See Figure 2

  1. Disconnect the shifter button with the spring.
  2.  
  3. Remove the snap ring, then remove the knob.
  4.  
  5. Remove the bolts from the console assembly.
  6.  
  7. Disengage the gear indicator bulb sockets from the bottom of the plate assembly, then remove the plate assembly.
  8.  
  9. Disengage the power auxiliary outlet connectors from the power auxiliary outlets.
  10.  
  11. Separate the bolts from the nuts at the rear of the console assembly.
  12.  
  13. Unfasten the bolts from the brace assembly.
  14.  
  15. Remove the console assembly.
  16.  
  17. Disengage the remote keyless entry connectors from the receiver, then disconnect the shift control and park lock cable. Disengage the electrical connector.
  18.  
  19. Separate the bolts from the nuts retaining the brace assembly.
  20.  
  21. Remove the brace assembly.
  22.  
  23. Installation is the reverse of removal.
  24.  



Click image to see an enlarged view

Fig. Fig. 2: Floor console components - Typhoon

Overhead Console
  1. Remove the dome lamp lens.
  2.  
  3. Unfasten the console-to-roof screws, then lower the console.
  4.  
  5. Disengage the electrical connectors, then remove the console assembly from the roof.
  6.  

To install:
  1. Raise the console to the roof, then engage the electrical connectors.
  2.  
  3. Align the console, then install the retaining screws. Tighten the screws to 19 inch lbs. (2.2 Nm).
  4.  
  5. Install the dome lamp lens.
  6.  

 
label.common.footer.alt.autozoneLogo