GM Blazer/Jimmy/Typhoon/Bravada 1983-1993 Repair Guide

Headliner

Print

REMOVAL & INSTALLATION



  1. Remove the sunshades:
    1. Disconnect the retaining screws, then remove the sunshade.
    2.  
    3. To remove the sunshade retainer, turn the screw until it extends from the retainer, then while pulling down on the retainer assembly, push in on the extended screw.
    4.  

  2.  
  3. If equipped, remove the overhead console. For details, please refer to the procedure located earlier in this section.
  4.  
  5. If equipped, remove the dome lamps.
  6.  
  7. Remove the left and right windshield garnish moldings, using J-38778 or equivalent.
  8.  
  9. Remove the assist handle by carefully prying off the cover, then removing the retaining screws.
  10.  
  11. Remove the body lock pillar and endgate upper garnish.
  12.  
  13. Remove the upper quarter panel trim.
  14.  
  15. Remove the headliner from the vehicle:
    1. Grasp the headliner on both sides.
    2.  
    3. Shift the headliner from side-to-side while lightly pulling down on the panel to disconnect the headliner from the roof.
    4.  

  16.  
  17. Remove the retainers from the trim panel.
  18.  
  19. Installation is the reverse of removal.
  20.  

 
label.common.footer.alt.autozoneLogo