Follow the above procedures, complete the rebuilding process as follows:
Fill the oil pump with oil, to prevent cavitating (sucking air) on initial engine start up. Install the oil pump and the pick-up tube on the engine. Coat the oil pan gasket as necessary, and install the gasket and the oil pan. Mount the flywheel and the crankshaft vibration damper or pulley on the crankshaft.
Always use new bolts when installing the flywheel.
Inspect the clutch shaft pilot bushing in the crankshaft. If the bushing is excessively worn, remove it with an expanding puller and a slide hammer, and tap a new bushing into place.
Position the engine, cylinder head side up. Lubricate the lifters, and install them into their bores. Install the cylinder head, and torque it as specified. Insert the pushrods and install the rocker shaft(s) or position the rocker arms on the pushrods. Adjust the valves.
Install the intake and exhaust manifolds, the carburetor(s), the distributor and spark plugs. Adjust the point gap and the static ignition timing. Mount all accessories and install the engine in the car. Fill the radiator with coolant, and the crankcase with high quality engine oil.