GM Camaro/Firebird 1993-1998 Repair Guide

Hydraulic Modulator Solenoid Valve Assembly

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the solenoid valve electrical connector.
  4.  
  5. Remove the 2 Torx® head bolts.
  6.  
  7. Remove the solenoid valve assembly.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Solenoid valve mounting on the hydraulic modulator assembly

To install:
  1. Verify that the solenoid lip seal is properly positioned on the new solenoid valve.
  2.  
  3. Position the solenoid so the connectors face each other.
  4.  
  5. Press down firmly by hand until the solenoid assembly flange seats on the modulator assembly.
  6.  
  7. Install the 2 Torx® head bolts. Tighten to 40 inch lbs. (4.5 Nm).
  8.  
  9. Attach the solenoid electrical connector.
  10.  
  11. Properly bleed the brake system.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo