GM Camaro/Firebird 1993-1998 Repair Guide

Rear Wheel Speed Sensor Jumper Harness

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable.
  2.  
  3. Detach the connector from the rear wheel speed sensor(s).
  4.  
  5. Remove the jumper harness grommet from the retainer.
  6.  
  7. Remove the upper jumper harness connector from the rear body pass-through connector.
  8.  

To install:
  1. Fasten the upper jumper harness connector to the rear body pass-through connector.
  2.  
  3. Attach the electrical connector to the wheel speed sensor(s).
  4.  
  5. Connect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo