GM Caprice 1990-1993 Repair Guide

BUMPERS

Print

REMOVAL & INSTALLATION



Front

See Figures 1 and 2



Click image to see an enlarged view

Fig. Fig. 1: Front bumper assembly removal - 1990



Click image to see an enlarged view

Fig. Fig. 2: Front bumper assembly removal - 1991-92

  1. Disconnect the negative battery cable. Raise and support the vehicle safely.
  2.  
  3. Properly support the bumper. As required, disconnect all the necessary electrical connections at the turn signal assemblies and the cornering light housings.
  4.  
  5. On the vehicles without the energy absorber type bumper, remove the bolts from the frame and remove the bumper.
  6.  
  7. On vehicles equipped with the energy absorber type bumper, remove the bolts from the reinforcement to the energy absorber (each side) and remove the bumper assembly.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

Rear

See Figures 3 and 4



Click image to see an enlarged view

Fig. Fig. 3: Rear bumper assembly - 1990



Click image to see an enlarged view

Fig. Fig. 4: Rear bumper assembly - 1991-93

  1. Disconnect the negative battery cable. Raise and support the vehicle safely.
  2.  
  3. Properly support the bumper. As required, disconnect all the necessary electrical connections at the tail light assembly housings.
  4.  
  5. On the vehicles without the energy absorber type bumper, remove the bolts from the frame and remove the bumper.
  6.  
  7. On vehicles equipped with the energy absorber type bumper, remove the bolts from the reinforcement to the energy absorber (each side) and remove the bumper assembly.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

 
label.common.footer.alt.autozoneLogo