GM Caprice 1990-1993 Repair Guide

Fenders

Print

REMOVAL & INSTALLATION



See Figures 1 through 6



Click image to see an enlarged view

Fig. Fig. 1: Fender assembly at cowl removal - 1990



Click image to see an enlarged view

Fig. Fig. 2: Fender at radiator support removal - 1990



Click image to see an enlarged view

Fig. Fig. 3: Fender wheelhouse assembly - 1991-93



Click image to see an enlarged view

Fig. Fig. 4: Fender at radiator support removal - 1991-93



Click image to see an enlarged view

Fig. Fig. 5: Fender assembly upper and lower braces - 1991-93



Click image to see an enlarged view

Fig. Fig. 6: Fender assembly at cowl removal - 1991-93

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the hood.
  4.  
  5. Raise and safely support the vehicle.
  6.  
  7. Remove the lower fender bolts and inner wheel house panel.
  8.  
  9. Remove the rocker panel molding.
  10.  
  11. Remove the lower front filler panel-to-fender bolts.
  12.  
  13. Remove the bolt from the support brace.
  14.  
  15. Remove the front end fascia-to-fender nuts and screws.
  16.  
  17. Remove the hood hinge-to-fender bolts.
  18.  
  19. Disconnect all electrical connections from horn, turn signal lamps, etc.
  20.  
  21. Remove the fender by sliding rearward and outward, at rear, with the aid of an assistant. Place an old blanket over the fender as to avoid scratches or dents.
  22.  

To install:
  1. Install the fender with the aid of an assistant. Place an old blanket over the fender as to avoid scratches or dents.
  2.  
  3. Connect all electrical connections to the horn, turn signal lamps, etc.
  4.  
  5. Install the hood hinge-to-fender bolts.
  6.  
  7. Install the front end fascia-to-fender nuts and screws.
  8.  
  9. Install the bolt at the support brace.
  10.  
  11. Install the lower front end filler panel-to-fender bolts.
  12.  
  13. Install the rocker panel molding.
  14.  
  15. Install the lower fender bolts and inner wheel house panel.
  16.  
  17. Install the hood.
  18.  
  19. Connect the negative battery cable. Align the fender and hood as necessary, placing existing shims in original positions.
  20.  

 
label.common.footer.alt.autozoneLogo