GM Caprice 1990-1993 Repair Guide

Trunk Lid

Print

REMOVAL & INSTALLATION



See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Rear trunk lid assembly removal

  1. Disconnect the negative battery cable. Open the trunk lid and place protective coverings over the rear fenders to protect the paint from damage.
  2.  
  3. Mark the location of the hinge-to-trunk lid bolts and disconnect the electrical connections and wiring from the lid, if equipped.
  4.  
  5. Using an assistant to support the lid, remove the hinge-to-lid bolts and the lid from the vehicle.
  6.  
  7. To install, reverse the removal procedures. Adjust the position of the trunk lid to the body.
  8.  

ALIGNMENT



See Figure 2



Click image to see an enlarged view

Fig. Fig. 2: Rear trunk lid torque rod adjustment

Rear compartment torque rods are adjustable to increase or decrease operating effort. To increase the amount of effort needed to raise the rear compartment lid or to decrease the amount of effort to close the lid, reposition the end of the rod to a lower torque rod adjusting notch. To decrease the amount of effort needed to raise the rear compartment lid or to increase the amount of effort to close the lid, reposition the end of the rod to a higher torque rod adjusting notch. Prop the trunk lid in full-open position to keep lid from falling when torque rods are disengaged from the torque rod bracket.

 
label.common.footer.alt.autozoneLogo