GM Caprice 1990-1993 Repair Guide

Power Door Lock Actuator

Print

REMOVAL & INSTALLATION



  1. Disconnect the negative battery cable. Remove the door panel.
  2.  
  3. Raise the window fully. Disconnect the electrical connector from the actuator.
  4.  
  5. Drive the rivet center pins out using an 1 / 8 in. punch and hammer, then using a 1 / 4 inch drill bit, remove the rivet head.
  6.  
  7. Remove the actuator rod and remove the door lock actuator.
  8.  
  9. Installation is the reverse of the removal procedure.
  10.  

 
label.common.footer.alt.autozoneLogo