GM Caprice 1990-1993 Repair Guide

Power Seat Motor

Print

REMOVAL & INSTALLATION



  1. Remove the front seat assembly and place upside down on a clean protected surface.
  2.  
  3. Disconnect the motor feed wires from the motors.
  4.  
  5. Remove the nut securing the front of the motor support bracket to the inboard adjuster and withdraw the assembly from the adjuster and the gearnut drives.
  6.  
  7. Disconnect the drive cables from the motors and complete removal of the support bracket with the motor attached.
  8.  
  9. Grind off the peened over end(s) of the grommet assembly securing the motor to the support and separate the motor(s) as required from the support.
  10.  
  11. Before installation, drill out the top end of the grommet assembly using a 3 / 16 inch drill.
  12.  
  13. Install the grommet assembly to the motor support bracket and secure the motor to the grommet using 3 / 16 inch rivet.
  14.  
  15. Install the support bracket with the motor attached and connect the drive cables to the motors.
  16.  
  17. Install the support bracket nuts securing the front of the motor support bracket to the inboard adjuster.
  18.  
  19. Connect the motor feed wires to the motors.
  20.  
  21. Install the front seat assembly.
  22.  

 
label.common.footer.alt.autozoneLogo