GM Cavalier/Sunbird/Skyhawk/Firenza 1982-1994

ABS Hydraulic Modulator Solenoid

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the negative battery cable.
  2.  
  3. Detach the solenoid electrical connector.
  4.  
  5. Unfasten the Torx® head bolts, then remove the solenoid assembly.
  6.  



Click image to see an enlarged view

Fig. Fig. 1: ABS modulator solenoid mounting

To install:
  1. Lubricate the O-rings on the new solenoid with clean brake fluid.
  2.  
  3. Position the solenoid so the connectors face each other.
  4.  
  5. Press down firmly by hand until the solenoid assembly flange seats on the modulator assembly.
  6.  
  7. Install the Torx® head bolts. Tighten to 40 inch lbs. (4.5 Nm).
  8.  
  9. Attach the solenoid electrical connector. Make sure the connectors are installed on the correct solenoids.
  10.  
  11. Properly bleed the brake system.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo